Contact us

PRE-MIX CONCRETE

Asphalt Patch

High performance permanent pot-hole patch.

SUGGESTED USES

  • "Cold Patch"
  • Ready-to-use in all weather conditions
  • Use without heating or mixing
  • Permanently bonds to old asphalt and open to traffic immediately
Safety Data Sheet
Concrete Calculator
Each 50lb bag will yield enough material to fill a 1 sqft pothole to a depth of 4 inches.
(1 bag fills a ½ cubic foot)
Kwik Mix Asphalt Patch meets the following specs based on AES Cold Mix Design evaluation
ISO Form F4.10.13E2
Asphalt Content ASTM D2172-92 5.2%
Static Stripping ASTM D1664-80 95-100%
Kinetic Stripping OPSS 1153-02-01 95%
Cohesion MTO LS-290 99.9%
  • Read safety instructions before using this product
For best results:
  1. Square off edges of the area to be patched and sweep out all loose particles.
  2. Place Asphalt Patch in the hole in layers of 2 inches thick.
    (Proper tamping between layers is important.).
  3. Compact the material with a hand tamper, roller, or by driving over the patch with a car tire.
Do’s
  • The permanent patch is ready for traffic immediately.
  • Potholes should be cleaned free of gas, oil, and grease, etc., before applying Kwik Mix Asphalt Patch
Don’ts
  • Do NOT put entire bag at once in the hole to be patched.

Asphalt Patch contains Petroleum Asphalt. As with any Petroleum based material, direct contact may irritate eyes and skin. Wear protective clothing: gloves and eye protection. If material gets into eyes, rinse with water immediately and contact a physician. Wash exposed skin areas with water. 

DO NOT TAKE INTERNALLY.

KEEP AWAY FROM CHILDREN AND PETS. 

Clean up with Mineral Spirits.

More about our products

All Products
Contact us